NOTE: Most product dimensions are approximate within manufacturing tolerances and in many cases are a close approximation after converting from metric.

Fixed Jaw and Threaded Tab or Fixed Jaw w/Lag Eye for 1/8" or 3/16" Cable, Metal or Wood Posts

$32.80
In stock
Item Number :
F-J62

The Fixed Jaw is an exposed, swaged, non-tensioning, face-of-the-post-mounted fitting that is suitable for use on level or pitched runs and is available for 1/8”, 3/16”, 1/4”, 5/16”, and 3/8” diameter 1x19 stainless steel cable.

FOR METAL POSTS
The Fixed Jaw can be used with any tensioning fitting on the opposite end of the run. This fitting attaches to the metal end post by installing a Threaded Tab into a pre-drilled and tapped hole in the end post and attaching the Fixed Jaw to the threaded tab with a button head screw. The cable is retained within the Fixed Jaw fitting by a ferrule swaged onto the end of the cable. Screw and threaded tab are sold separately. 

While this fitting can be used on pitched or level runs, it is most appropriate for pitched runs because the Fixed Jaw pivots at the tab. Use of this fitting requires an appropriately sized ferrule that is swaged onto the cable, which must be purchased separately.
.
This fitting was designed to be compatible in appearance to the Adjust-A-Jaw® tensioning fitting.

Choose Ferrule Item F-4 for 1/8" Cable

Choose Ferrule item F-6 for 3/16" Cable

Choose Screw item SC-6 for 1/8" or 3/16" Cable

Choose Threaded Tab item TT-6B for 1/8" or 3/16" Cable

FOR WOOD POSTS
The Fixed Jaw must be used with a tensioning fitting on the opposite end of the run. This fitting attaches to the wood end post by installing a Lag Eye into a pre-drilled hole in the end post and attaching the Fixed Jaw to the lag eye with a button head screw. The cable is retained within the Fixed Jaw by a ferrule swaged onto the end of the cable.

While this fitting can be used on pitched or level runs, it is most appropriate for pitched runs because the Fixed Jaw pivots at the lag eye. The pre-drilled hole for the lag eye is drilled level, making installation easy.

Use of this fitting requires an appropriately sized ferrule that is swaged onto the cable, which must also be purchased separately.

This fitting was designed to be compatible in appearance to the Adjust-A-Jaw® tensioning fitting.

Choose Ferrule Item F-4 for 1/8" Cable

Choose Ferrule item F-6 for 3/16" Cable

Choose Screw item SC-6 for 1/8" or 3/16" Cable

Choose Lag Eye item LE-6 for 1/8" or 3/16" Cable

More Information

More Information
Item Number F-J62
Weight 0.5 lbs
Brands Ultra-tec
Cable Size 1/8" Cable, 3/16" Cable
Post Material Metal, Wood
Fittings Swaged non-tensioning fittings